Knowledge Center2019-03-04T21:06:45+00:00

Welcome to theKnowledge Center

We are here to help.

If you cannot find what you are looking for below, we are standing by to help you with your battery needs. Feel free to contact us anytime and talk to a real person. We have a full technical support staff here Monday through Friday from 7:30 am to 4:00 pm.

Technical Info

Most Common FAQs

What does AGM stand for?2019-03-04T21:06:46+00:00
It stands for Absorbed Glass Mat, the type of separator used in all Lifeline® AGM batteries.
What is the difference between AGM batteries and Gel batteries?2019-03-04T21:06:46+00:00
Both AGM and Gel batteries utilize oxygen recombination and pressure relief valves to minimize water loss and allow maintenance-free operation. That is where the similarities end. AGM batteries have the advantage of being mountable in any orientation without capacity loss, have lower internal impedance to support high load currents, and have better capacity at lower temperatures. Gel batteries must be mounted upright to prevent air pockets from forming that will burn out the plates. They have inferior performance at high discharge rates and low temperatures.
Can Lifeline® AGM batteries be installed in sealed containers?2015-12-29T17:40:08+00:00
NO! Do not install Lifeline® AGM batteries in a sealed container or enclosure. During storage, charging, or discharging hydrogen gas can be released and must be ventilated to prevent the possibility of ignition and/or explosion.
How can I tell if my battery is fully charged?2015-12-29T17:40:17+00:00
For a battery at room temperature, it can be considered fully charged with the charging current falls below 0.5A per 100Ah of rated capacity. The open circuit voltage (after at least 4 hours of rest) will be 2.17 volts per cell or higher (13.0 volts for a 12-volt battery), regardless of the battery temperature.
What causes some batteries to have convex or concave end walls?2015-12-29T17:40:25+00:00
Lifeline® AGM batteries contain a pressure relief valve (PRV) that prevents excessive pressure buildup when the battery is being charged, and automatically reseals once the pressure is released. A slight bulge in the battery container (convex end walls) can appear when the internal pressure is above the surrounding atmospheric pressure but not enough to open the PRV. Alternatively, the end walls can flex inward (concave end walls) when the internal pressure is less than surrounding atmospheric pressure. Both of these conditions are normal and do not affect the battery's operation.

See All FAQs

Calculators

Which Lifeline Battery fits your needs? Use our calculators to consider power requirements, space allocation, charging protocol, weight restrictions, safety considerations and budget planning.

Resources

Compare Battery Types
A description of battery types compared with possible illustrations.

Glossary
Define select terms